Home Forum Blog Private Support Courses
Our courses are now on YouTube! Start Watching
Hovatek Forum HARDWARE Boxes and Dongles [Tutorial] How to use Hydra tool to bypass FRP on Mediatek

[Tutorial] How to use Hydra tool to bypass FRP on Mediatek

[Tutorial] How to use Hydra tool to bypass FRP on Mediatek

 View a Printable Version
 
hovatek
hovatek
hovatek
Administrator
Website Find
50,890
30-08-2024, 11:01 AM
#1



This guide will show you how to remove/bypass Factory Reset Protection (FRP) on a Mediatek smartphone using Hydra dongle MTK module.

Requirements


Steps to bypass FRP on Mediatek using Hydra tool



See the video tutorial below or @ https://youtu.be/Q1dT8fV1RuA


  1. Run Hydra Tool as administrator
  2. Double-click on MTK to access the section.
  3. Click on the "Service" Tab, then select "Tool" under it

    [Image: How-to-clear-FRP-on-MTK-USING-Hydra-Tool-1.png]

  4. Click on the drop-down menu and select "FACTORY RESET PROTECTION [FRP]".
  5. Under the dropdown menu, you will see a list of options. Keep it at "Flashmode > Auto"
  6. Click Execute, You’ll see a prompt to confirm the operation click "Yes" to proceed

    [Image: How-to-clear-FRP-on-MTK-USING-Hydra-Tool-2.png]

  7. Power off and connect your device. The process will start once your device is detected.

    [Image: How-to-clear-FRP-on-MTK-USING-Hydra-Tool-3.png]

  8. Wait till its done

    [Image: How-to-clear-FRP-on-MTK-USING-Hydra-Tool-4.png]

  9. Disconnect and Reboot the phone


Important notice

  • If you can't connect your phone in brom mode using the key combination, consider using the test point method.
This post was last modified: 06-09-2024, 05:38 PM by hovatek.
Learn MediaTek, Unisoc / Spreadtrum (SPD) and Qualcomm Software Repairs @ https://www.hovatek.com/training
Note!
We have a reply schedule for Forum Support. Please try Private Support if you can't wait.
Reply
Reply
 View a Printable Version
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)
WhTlYt