24-02-2019, 03:22 PM
This guide will show you how to use miracle box / thunder to fix null IMEI / write IMEI to your mediatek device.
Requirements
- Download latest miracle box / thunder
- Install Vcom preloader drivers on the PC
- Ensure your phone has a valid Baseband (Settings > About > Baseband). Reflash the firmware if it's unknown
Steps to write IMEI onto mediatek device (MTK) using Miracle Box
Follow the steps below to write IMEI to a mediatek device using Miracle box
- Launch Miracle box
- On Miracle box interface, press Control + M to enable IMEI
- Tick the check box beside IMEI(switched off)
- Tick the check box beside NEW(BT)
- Leave the phone's chipset type as 4th Boot(Auto Connect)
- Input the original IMEI into the IMEI boxes
- Click Start
- You should now see >>> Waiting for USB Port... At this point, switch off the phone then connect it to the PC via USB cord without holding any buttons
- The phone should get detected and IMEI writing should begin
- Once the process is complete, you should see 'IMEI OK'
Important Notice
- Best to use latest version of miracle (usually miracle thunder) as it supports more chipsets than older versions
- Miracle Box requires a hardware box / dongle to work. Merely installing the setup and trying to run the tool (without having connected the hardware to the PC) won't work unless you are using a loader version
- Using the loader version might trigger an antivirus warning. While this might be a false positive, you are entirely responsible for allowing the loader to run on your PC
- If this method fails to work for whatever reason then you can always use the other methods
- If you get the inactive start button error when using Miracle, then see the Miracle Box inactive start button fix
Video Transcript
Quote:In this video tutorial, I'm going to be showing how to write IMEI onto a mediatek android phone using miracle box
So I'm launching miracle box tool. On the miracle box interface, we'll press Ctrl key + M to enable IMEI
Now click IMEI (switched off). Tick the check box beside NEW(BT). This mode will make it connect to the phone using preloader ports
Now write the original IMEI of the device. Finally, we'll click the start button
Once we click start button we'll connect the android phone using USB cable to the PC
You can see the device is connected as preloader
Once IMEI is written successfully, you'll get the message IMEI OK. Now we can disconnect the phone from the PC
Remove the battery, Re-insert the battery and power on the phone to check
So we can see the IMEI we've written 749, 749.