I had just unbricked a dead boot Tecno Pop 7 Pro (BF7). Its original issue was that Wi-Fi, Bluetooth, and Hot Spot couldn’t be turned on. The Microphone also stopped functioning during phone calls. All these began after flashing a Magisk-patched boot.img. This might happen when the boot.img is incompatible (e.g. for a different variant or build number).
I chose to flash via fastboot since the bootloader was still unlocked after unbricking it and I wouldn’t require a paid tool (since this model requires a preloader exploit/auth.). First, I checked the active slot:
fastboot getvar current-slot
then I set an active slot
fastboot --set-active=a
I then flashed the firmware via fastboot (I created a Windows batch file to automate the process):
preloader(preloader_bf7_h6127.bin), 242.98 KB = Ok
- md1img_a(md1img.img), 48.838 MB = Ok
- spmfw_a(spmfw.img), 62.984 KB = Ok
- scp_a(scp.img), 556.438 KB = Ok
- sspm_a(sspm.img), 432.422 KB = Ok
- lk_a(lk.img), 985.313 KB = Ok
- logo_a(logo.bin), 1.497 MB = Ok
- boot_a(boot.img), 32 MB = Ok
- dtbo_a(dtbo.img), 8 MB = Ok
- tee_a(tee.img), 863.344 KB = Ok
- tkv_a(tkv.img), 1024 KB = Ok
- vbmeta_a(vbmeta.img), 4 KB = Ok
- vbmeta_system_a(vbmeta_system.img), 4 KB = Ok
- vbmeta_vendor_a(vbmeta_vendor.img), 4 KB = Ok
- logo_b(logo.bin), 1.497 MB = Ok
- super(super.img), 5.623 GB = Ok
- tranfs(tranfs.img), 88.145 KB = Ok
- userdata(userdata.img), 109.582 MB
Note The firmware should match the current build number and you should only reflash the entire firmware if flashing boot.img alone doesn’t address the issue.
I then rebooted
fastboot reboot
Conclusion
This fixed the issue. I however noticed that the device gets stuck in BROM Mode whenever its powered off and I have to wake it up using MTK Client
python mtk.py plstage --preloader=preloader_bf7_h6127.bin
This, I shall get to the bottom of and drop a follow up tutorial.

