Home Forum Blog Private Support Courses Archive

My Experience fixing Wi-Fi, Hotspot & Bluetooth not turning on after rooting Tecno Pop 7 Pro (BF7)

I had just unbricked a dead boot Tecno Pop 7 Pro (BF7). Its original issue was that Wi-Fi, Bluetooth, and Hot Spot couldn’t be turned on. The Microphone also stopped functioning during phone calls. All these began after flashing a Magisk-patched boot.img. This might happen when the boot.img is incompatible (e.g. for a different variant or build number).

I chose to flash via fastboot since the bootloader was still unlocked after unbricking it and I wouldn’t require a paid tool (since this model requires a preloader exploit/auth.). First, I checked the active slot:

fastboot getvar current-slot

then I set an active slot

fastboot --set-active=a

I then flashed the firmware via fastboot (I created a Windows batch file to automate the process):

preloader(preloader_bf7_h6127.bin), 242.98 KB       =  Ok
 - md1img_a(md1img.img), 48.838 MB                     =  Ok
 - spmfw_a(spmfw.img), 62.984 KB                       =  Ok
 - scp_a(scp.img), 556.438 KB                          =  Ok
 - sspm_a(sspm.img), 432.422 KB                        =  Ok
 - lk_a(lk.img), 985.313 KB                            =  Ok
 - logo_a(logo.bin), 1.497 MB                          =  Ok
 - boot_a(boot.img), 32 MB                             =  Ok
 - dtbo_a(dtbo.img), 8 MB                              =  Ok
 - tee_a(tee.img), 863.344 KB                          =  Ok
 - tkv_a(tkv.img), 1024 KB                             =  Ok
 - vbmeta_a(vbmeta.img), 4 KB                          =  Ok
 - vbmeta_system_a(vbmeta_system.img), 4 KB            =  Ok
 - vbmeta_vendor_a(vbmeta_vendor.img), 4 KB            =  Ok
 - logo_b(logo.bin), 1.497 MB                          =  Ok
 - super(super.img), 5.623 GB                          =  Ok
 - tranfs(tranfs.img), 88.145 KB                       =  Ok
 - userdata(userdata.img), 109.582 MB          

Note The firmware should match the current build number and you should only reflash the entire firmware if flashing boot.img alone doesn’t address the issue.

I then rebooted

fastboot reboot

Conclusion

This fixed the issue. I however noticed that the device gets stuck in BROM Mode whenever its powered off and I have to wake it up using MTK Client

python mtk.py plstage --preloader=preloader_bf7_h6127.bin

This, I shall get to the bottom of and drop a follow up tutorial.

Leave a Comment

Your email address will not be published. Required fields are marked *

WhTlYt
Scroll to Top