We're hiring! Apply Now

Hovatek Forum MOBILE Android Tecno Phantom X Flashing

Tecno Phantom X Flashing

Tecno Phantom X Flashing

uzanem
uzanem
uzanem
Newbie
4
26-10-2023, 09:45 AM
#1



I am Unable to flash my phone tecno AC8, using sp flash tool, i also have nck loader, but the scatter file format is not supported on it. but it is supported on the sp flash tool. please what am i required to do?
AutoResponder
AutoResponder
AutoResponder
Verified Account
609
26-10-2023, 09:45 AM
#2
Thank you for reaching out for support. Due to high demand, our free support services may experience some delays in response time. We apologize for any inconvenience this may cause.
Alternatively, we offer private support where you can receive dedicated attention and prompt support. These sessions are designed to provide personalized solutions to your specific needs.
If you are interested in scheduling a private session, please visit https://www.hovatek.com/remote
maxpayne
maxpayne
maxpayne
Intern
4,101
26-10-2023, 10:54 AM
#3
(26-10-2023, 09:45 AM)uzanem I am Unable to flash my phone tecno AC8, using sp flash tool, i also have nck loader, but the scatter file format is not supported on it. but it is supported on the sp flash tool. please what am i required to do?

You can use MTK client https://www.hovatek.com/forum/thread-40866.html

or you set it up then run

Code:

py -3 mtk payload

once this completes, just flash with SP flash tool without disconnecting

Note!
We have a reply schedule for Free Support. Please upgrade to Private Support if you can't wait.
uzanem
uzanem
uzanem
Newbie
4
26-10-2023, 12:17 PM
#4
(26-10-2023, 10:54 AM)maxpayne
(26-10-2023, 09:45 AM)uzanem I am Unable to flash my phone tecno AC8, using sp flash tool, i also have nck loader, but the scatter file format is not supported on it. but it is supported on the sp flash tool. please what am i required to do?

You can use MTK client https://www.hovatek.com/forum/thread-40866.html

or you set it up then run

Code:

py -3 mtk payload

once this completes, just flash with SP flash tool without disconnecting
it connects and disconnect, even though i have the vcom drivers installed. it shows "Preloader - [LIB]: ←[31mStatus: Handshake failed, retrying...←[0m".
uzanem
uzanem
uzanem
Newbie
4
26-10-2023, 12:22 PM
#5



how do i enter Brom mode of TEcno Phantom X
maxpayne
maxpayne
maxpayne
Intern
4,101
27-10-2023, 06:06 AM
#6
(26-10-2023, 12:22 PM)uzanem how do i enter Brom mode of TEcno Phantom X

Power off then hold both volume buttons and connect to laptop

Note!
We have a reply schedule for Free Support. Please upgrade to Private Support if you can't wait.
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)
Join us
WhTlYt