Can someone please helpm I have a tablet running mt8163 its bricked but I can get it to register to flash...the problem is the USB has two interfaces 0 and 1 interface 0 has a protocol to interrupt periodically so when I'm flashing the boot system recovery ect it won't finish it cute off after 2-5 seconds but if I use a test point the USB stays activated but I get error sending from stage2:00 everything goes through up until that point how can I either fix the USB interface so It will stay on without using test point or how do I get pass stage2 brom?!? The dram config registers as all 0's sometimes when I'm using test point also but not eveytime?!!Device Info
Device Path: /dev/bus/usb/001/120
Device Class: Communication Device (0x2)
Vendor ID: 0e8d
Vendor Name (reported):
Vendor Name (from DB): MediaTek Inc.
Product ID: 0003
Product Name (reported):
Product Name (from DB): MT6227 phone
Additional Info
Interface #0
Class: Communication Device (0x2)
Endpoint: #0
Address : 0x84 (10000100)
Number : 4
Direction : Inbound (0x80)
Type : Interrupt (0x3)
Poll Interval : 1
Max Packet Size: 64
Attributes : 00000011
Interface #1
Class: Communication Device Class (CDC) (0xa)
Endpoint: #0
Address : 0x81 (10000001)
Number : 1
Direction : Inbound (0x80)
Type : Bulk (0x2)
Poll Interval : 0
Max Packet Size: 64
Attributes : 00000010
Endpoint: #1
Address : 0x01 (00000001)
Number : 1
Direction : Outbound (0x0)
Type : Bulk (0x2)
Poll Interval : 0
Max Packet Size: 64
Attributes : 00000010
Thank you for reaching out for support. Due to high demand, our free support services may experience some delays in response time. We apologize for any inconvenience this may cause.
Alternatively, we offer private support where you can receive dedicated attention and prompt support. These sessions are designed to provide personalized solutions to your specific needs.
If you are interested in scheduling a private session, please visit https://www.hovatek.com/remote
