Bricked Redmi9a not recognized by PC
Bricked Redmi9a not recognized by PC
(08-10-2023, 12:04 AM)jopali Hello, I unloacked bootloader and installed Orange fox succesfully on my Redmi 9a and then I bricked it while trying to flash ArrowOS. At that time the phone just vibrated when holding the power button but the screen did not turn on. I tried using SP flashing tool.
I installed the Python3.9.1, MTK driver and libUSB and run broom.bat
cmd opened up telling me its waiting for a device
I plugged in my bricked phone pressing both vol+ and vol- at the same time until I got the message "protection disabled"
Launched the SP Flash tool and got the error status_err(0xC0010001). Since then phone is no longer recognized by PC. I am running Windows 10. The windows error message is somethiong like that:
The usb device is not recognized.
The last usb device you connected to this computer didn't work properly, and windows didn't recognize it.
Anyone who could help?
python mtk payload(09-10-2023, 09:49 AM)maxpayne(08-10-2023, 12:04 AM)jopali Hello, I unloacked bootloader and installed Orange fox succesfully on my Redmi 9a and then I bricked it while trying to flash ArrowOS. At that time the phone just vibrated when holding the power button but the screen did not turn on. I tried using SP flashing tool.
I installed the Python3.9.1, MTK driver and libUSB and run broom.bat
cmd opened up telling me its waiting for a device
I plugged in my bricked phone pressing both vol+ and vol- at the same time until I got the message "protection disabled"
Launched the SP Flash tool and got the error status_err(0xC0010001). Since then phone is no longer recognized by PC. I am running Windows 10. The windows error message is somethiong like that:
The usb device is not recognized.
The last usb device you connected to this computer didn't work properly, and windows didn't recognize it.
Anyone who could help?
You're getting that error because of the interruption in SP flash tool
Hold Power + volume down buttons for 30 seconds then try flash again
https://www.hovatek.com/forum/thread-808.html
You could also use MTK client + sp flash tool
The command would be
Code:python mtk payload
then you flash with sp flash tool
(11-10-2023, 08:28 PM)jopali I tried this, holding Power + volume down buttons for 30 seconds but know the device even don't makes a sound when connected to a PC.I think it drained after I tried so many times. After that I tried to charge it for a complete day, as described in your link (https://www.hovatek.com/forum/thread-808.html) but until now without success. I read that a few guys waited for several days. Do you think I need to wait more time?
