[Denverfan9]

I just finished dumping the stock rom with wwr and sp the device is mt8768 i created and used mt6765 scatter to dump i did this same method on another device with the same 8768 successfully only hangup right now is looks like this tab 10 has A/B partition. Which boot & vbmeta .img do i use or do i patch/flash both a & b boot.img?


Thank you

[hovatek]

I just finished dumping the stock rom with wwr and sp the device is mt8768 i created and used mt6765 scatter to dump i did this same method on another device with the same 8768 successfully only hangup right now is looks like this tab 10 has A/B partition. Which boot & vbmeta .img do i use or do i patch/flash both a & b boot.img?


Thank you

You can use either boot, just flash to active slot. Use the normal vbmeta

[Denverfan9]

I just finished dumping the stock rom with wwr and sp the device is mt8768 i created and used mt6765 scatter to dump i did this same method on another device with the same 8768 successfully only hangup right now is looks like this tab 10 has A/B partition. Which boot & vbmeta .img do i use or do i patch/flash both a & b boot.img?


Thank you

You can use either boot, just flash to active slot. Use the normal vbmeta

Appreciate the fast reply!. how do i tell which partition is the active slot?

thanks

[Abdulakeem14]

I just finished dumping the stock rom with wwr and sp the device is mt8768 i created and used mt6765 scatter to dump i did this same method on another device with the same 8768 successfully only hangup right now is looks like this tab 10 has A/B partition. Which boot & vbmeta .img do i use or do i patch/flash both a & b boot.img?


Thank you

You can use either boot, just flash to active slot. Use the normal vbmeta

Appreciate the fast reply!. how do i tell which partition is the active slot?

thanks

Enter the command below in fastboot,
"fastboot getvar all"
Then check for (bootloader) current-slot: