27-04-2022, 05:42 PM
(31-01-2022, 09:37 PM)Cindeade Wrote: Here is the log..I removed some personal data..
Port - Device detected
Preloader - CPU: MT8167/MT8516/MT8362()
Preloader - HW version: 0x0
Preloader - WDT: 0x10007000
Preloader - Uart: 0x11005000
Preloader - Brom payload addr: 0x100a00
Preloader - DA payload addr: 0x201000
Preloader - CQ_DMA addr: 0x10212c00
Preloader - Var1: 0xcc
Preloader - Disabling Watchdog...
Preloader - HW code: 0x8167
Preloader - Target config: 0xe0
Preloader - SBC enabled: False
Preloader - SLA enabled: False
Preloader - DAA enabled: False
Preloader - SWJTAG enabled: False
Preloader - EPP_PARAM at 0x600 after EMMC_BOOT/SDMMC_BOOT: False
Preloader - Root cert required: False
Preloader - Mem read auth: True
Preloader - Mem write auth: True
Preloader - Cmd 0xC8 blocked: True
Preloader - Get Target info
Preloader - BROM mode detected.
Preloader - HW subcode: 0x8a00
Preloader - HW Ver: 0xcb00
Preloader - SW Ver: 0x1
Preloader - ME_ID: x
Preloader - SOC_ID: 0000000000000000000000000000000000000000000000000000000000000000
DA_handler - Device is unprotected.
DA_handler - Device is in BROM-Mode. Bypassing security.
PLTools - Loading payload from mt8167_payload.bin, 0x264 bytes
PLTools - Kamakiri / DA Run
Kamakiri - Trying kamakiri2..
Kamakiri - Done sending payload...
PLTools - Successfully sent payload: C:\mtkclient\payloads\mt8167_payload.bin
Port - Device detected
DA_handler
DA_handler - [LIB]: ←[33mDevice is in BROM mode. No preloader given, trying to dump preloader from ram.←[0m
DAXFlash - Uploading xflash stage 1 from MTK_AllInOne_DA_5.2136.bin
DAXFlash - Successfully uploaded stage 1, jumping ..
Preloader - Jumping to 0x200000
Preloader - Jumping to 0x200000: ok.
DAXFlash - Successfully received DA sync
DAXFlash - Sending emi data ...
DAXFlash - Sending emi data succeeded.
DAXFlash - Uploading stage 2...
DAXFlash
DAXFlash - [LIB]: ←[31mError on sending data: DA hash mismatch (0xc0070004)←[0m
DAXFlash
DAXFlash - [LIB]: ←[31mError on booting to da (xflash)←[0m
DA_handler
DA_handler - [LIB]: ←[31mError uploading da←[0m
It works fine til it starts uploading stage 2..then errors...
Tried to continue but the commands they just give errors...
I also have A working Hello 10, Witch has the same hardware but 10 inch screen .
This one works, so i tried to do the bypass.. but I get the same errors ..Wanted to be shure it was not because it was stuck in bootloader.
The MT8167 seems to be A hard nut to crack.. but I hope to get it running again..had it for 1 day before I messed it up.
How did you get this information? What software did you use?