Tecno Spark 3 Pro stuck in boot loop
Tecno Spark 3 Pro stuck in boot loop
fastboot reboot
(21-12-2021, 08:57 PM)elfkuzco I tried to root my phone using magisk and fastboot but after runningĀ
my device has been stuck in a boot loop. I let the battery drain down as it is in-built but while trying to charge it, it begins the boot loop again which I think is stopping SP Flash tool working because when it powers on, SP Flash tool shows an error message. I can't get to recovery mode using the Power + Volume Up or Volume Down combinations, either.Code:fastboot reboot
I browsed about the orange state message which it shows on the boot screen but the solution I keep seeing involves using mtk-bypass utility and SP Flash tool, but the phone can't stay off.
(23-12-2021, 03:39 PM)hovatek(21-12-2021, 08:57 PM)elfkuzco I tried to root my phone using magisk and fastboot but after runningĀ
my device has been stuck in a boot loop. I let the battery drain down as it is in-built but while trying to charge it, it begins the boot loop again which I think is stopping SP Flash tool working because when it powers on, SP Flash tool shows an error message. I can't get to recovery mode using the Power + Volume Up or Volume Down combinations, either.Code:fastboot reboot
I browsed about the orange state message which it shows on the boot screen but the solution I keep seeing involves using mtk-bypass utility and SP Flash tool, but the phone can't stay off.
Download the DA @ https://www.hovatek.com/forum/thread-23243.html and flash using SP flash tool.
You just connect the phone when SP flash tool is ready and it should detect the phone and commence flashing
(23-12-2021, 10:39 PM)kelvinchinedu Plug the phone to PC and leave it for some few minutes and remove it and try holding down the power botton for 10-30 seconds and see if it can power on .if fail remove the battery complete and try reflashing only preloader
(23-12-2021, 09:17 PM)elfkuzco Ok. I tried flashing with SP tool and mtk-bypass utility as I found out the device is using secure boot and the DA files didn't work with my stock firmware. SP flash tool was showing an error when I loaded the DA file. So, while I was flashing using mtk-bypass utility and SP Flash tool All_In_One_DA file, the USB connection got interrupted and I had to stop the download. Since then, the phone won't turn on or charge again or show the boot loop behaviour it was exhibiting before. It's just dead. Saw a thread about charging it for days but I have been doing that and no response so far
(25-12-2021, 05:46 AM)hovatek(23-12-2021, 09:17 PM)elfkuzco Ok. I tried flashing with SP tool and mtk-bypass utility as I found out the device is using secure boot and the DA files didn't work with my stock firmware. SP flash tool was showing an error when I loaded the DA file. So, while I was flashing using mtk-bypass utility and SP Flash tool All_In_One_DA file, the USB connection got interrupted and I had to stop the download. Since then, the phone won't turn on or charge again or show the boot loop behaviour it was exhibiting before. It's just dead. Saw a thread about charging it for days but I have been doing that and no response so far
That would be https://www.hovatek.com/forum/thread-808.html
What error did you get with the DA? LIB DA mismatch?