How to detect a Mediatek tablet in BROM mode via OTG with another Mediatek tablet

[legalpet]

I have successfully been using mtkclient to flash tablets with MT8163 chipset. However, instead of using my PC, I would like to use one of my Mediatek tablets to flash another Mediatek tablet with OTG.

The tablets are OTG compatible; I can transfer files no problem.

I have successfully setup mtkclient in Termux on a rooted Mediatek tablet.

However, in Termux when mtkclient asks to connect the device, it won't detect it in BROM mode when I plug it in with OTG cable.

Is there anything I can do or look into to try and get it to detect?

Thanks.

[maxpayne]

I have successfully been using mtkclient to flash tablets with MT8163 chipset. However, instead of using my PC, I would like to use one of my Mediatek tablets to flash another Mediatek tablet with OTG.

The tablets are OTG compatible; I can transfer files no problem.

I have successfully setup mtkclient in Termux on a rooted Mediatek tablet.

However, in Termux when mtkclient asks to connect the device, it won't detect it in BROM mode when I plug it in with OTG cable.

Is there anything I can do or look into to try and get it to detect?

Thanks.

You best contact the developer about this since Windows relies on USBDK / LIBUSB to achieve such detection

[legalpet]

I contacted the developer; he is too busy to help with this unfortunately.

Can you offer any advice for how I might go about accomplishing this task? It would be very helpful if I could achieve this goal.