My spark 5 pro is in red mode I need help to flash it
My spark 5 pro is in red mode I need help to flash it
(11-03-2021, 11:28 AM)Shy Nodi I tried flashing my Tecno spark 5 pro with a firmware I got here from hovatek using sp flash tool without disabling verified boot, it failed and showed error sec img_type mismatch, at this point the phone entered red mode and started rebooting so I tried using software download tool, at first it failed then I generated checksum and tried again, this time it went a bit further but failed again saying the same error sec img type mismatch. Pls the phone is still in red mode and won't flash what can I do?did you use the right da when flashing?
(11-03-2021, 11:28 AM)Shy Nodi I tried flashing my Tecno spark 5 pro with a firmware I got here from hovatek using sp flash tool without disabling verified boot, it failed and showed error sec img_type mismatch, at this point the phone entered red mode and started rebooting so I tried using software download tool, at first it failed then I generated checksum and tried again, this time it went a bit further but failed again saying the same error sec img type mismatch. Pls the phone is still in red mode and won't flash what can I do?
(11-03-2021, 04:06 PM)Abdulakeem14Yes I did(11-03-2021, 11:28 AM)Shy Nodi I tried flashing my Tecno spark 5 pro with a firmware I got here from hovatek using sp flash tool without disabling verified boot, it failed and showed error sec img_type mismatch, at this point the phone entered red mode and started rebooting so I tried using software download tool, at first it failed then I generated checksum and tried again, this time it went a bit further but failed again saying the same error sec img type mismatch. Pls the phone is still in red mode and won't flash what can I do?did you use the right da when flashing?
(12-03-2021, 09:40 AM)X3nonI've tried that it still showed the same error, and with miracle thunder it says boot not support or cpu bad with boot8 but the phone still comes on to red mode and I even tried boot 11 and 15 but when it gets to downloading boot it just stops(11-03-2021, 11:28 AM)Shy Nodi I tried flashing my Tecno spark 5 pro with a firmware I got here from hovatek using sp flash tool without disabling verified boot, it failed and showed error sec img_type mismatch, at this point the phone entered red mode and started rebooting so I tried using software download tool, at first it failed then I generated checksum and tried again, this time it went a bit further but failed again saying the same error sec img type mismatch. Pls the phone is still in red mode and won't flash what can I do?
try flashing each of the files one after the other, note all that fail with this verified boot error
then retry flashing all that failed using spft along with the DA @ https://mega.nz/file/Q4JHUKpL#kdCWpu_602...Z8IBk9t6dU
OR then retry flashing all that failed using miracle thunder 2.82 @ https://www.hovatek.com/forum/thread-14106.html
let me know if any works
(12-03-2021, 11:52 AM)Shy Nodi ...
I've tried that it still showed the same error, and with miracle thunder it says boot not support or cpu bad with boot8 but the phone still comes on to red mode and I even tried boot 11 and 15 but when it gets to downloading boot it just stops
(14-03-2021, 03:03 PM)Shy Nodi I used the da i got here from hovatek on both SPFT and MT but the same error still came up
(14-03-2021, 06:03 PM)Chijohn(14-03-2021, 03:03 PM)Shy Nodi I used the da i got here from hovatek on both SPFT and MT but the same error still came up
Cm2 tool will do the job.its will write the needed files for the phone to work again with ultra supported.