Doogee S88 unresponsive after rooting
Doogee S88 unresponsive after rooting
(29-10-2020, 10:02 AM)LukyKuki2000 Guide in question: https://www.hovatek.com/forum/thread-35862.html
Hey, so I've followed the lazy / faint hearted steps and all went well up until the third step, which I might have misunderstood.
After using magisk I've let the phone discharge. After recharging it, I've started android for about 5s until it turned off again, presumably from low battery charge. Now, however, the phone behaves as if it were at 0% battery. It doesn't start and the only feedback I have is the red LED turning on when I charge it. Any advice?
Quote:is your device s88 pro or s88? if s88 pro, does the build number of your device match the build number indicated in that thread?
have you tried disconnecting / reconnecting the battery of the device? and it's still dead?
(30-10-2020, 10:37 AM)LukyKuki2000 No, I haven't tried disconnecting the battery, hoped it wouldn't come to it. The device is s88 pro, I'm not aware of a non-pro version. As to the build number, I don't see any in the thread except for the signed boot.img.
(29-10-2020, 10:02 AM)LukyKuki2000 Guide in question: https://www.hovatek.com/forum/thread-35862.html
Hey, so I've followed the lazy / faint hearted steps and all went well up until the third step, which I might have misunderstood.
After using magisk I've let the phone discharge. After recharging it, I've started android for about 5s until it turned off again, presumably from low battery charge. Now, however, the phone behaves as if it were at 0% battery. It doesn't start and the only feedback I have is the red LED turning on when I charge it. Any advice?
Quote:Connect it to wall charger then hold the power button for about 20 seconds.
I'm curious to know why you let the phone discharge. Why didn't you power up immediately after flashing the patched boot?
Have you tried flashing stock boot.img from the firmware?
(04-11-2020, 09:51 PM)LukyKuki2000 ... Any idea where/if I may find a teardown?
(04-11-2020, 09:51 PM)LukyKuki2000 When connected to the charger, the red LED blinks after 20s, that seems to be about it.
I've let the phone discharge after seeing X3non's answer in the comments.
I admittedly don't know how to flash img from firmware, this is my first time doing it, but I don't have any access to the device.
As to the previous comment, I've managed to get hold of tools to disassemble the phone, but am not certain how to access the battery. Any idea where/if I may find a teardown?
(09-11-2020, 08:16 AM)hovatek I suggest you hold off on disassembling (till you see a clear guide) so you don't make things worse.
Is seems your device got stuck in flash mode (not certain yet). The steps @ https://www.hovatek.com/forum/thread-808.html should help but lets first try flashing the firmware.
Have you downloaded the firmware for this model to begin?