LG Stylo 6 (MT6765) SP Flash Tool successful connection
LG Stylo 6 (MT6765) SP Flash Tool successful connection
(16-07-2021, 06:03 AM)Mastercodeon314 ...
I am hoping someone here has some insight on this and could definitely use help moving forward.
Im not sure what exactly what im missing, but I suspect that I need to disable the mtk auth for full access to the device in sp flash, then flash a backup of a clean stylo.
Please contact me on discord @ Mastercodeon#4497, and ill connect you to the admin of the server im helping out with.
(16-07-2021, 07:27 AM)hovatek(16-07-2021, 06:03 AM)Mastercodeon314 ...
I am hoping someone here has some insight on this and could definitely use help moving forward.
Im not sure what exactly what im missing, but I suspect that I need to disable the mtk auth for full access to the device in sp flash, then flash a backup of a clean stylo.
Please contact me on discord @ Mastercodeon#4497, and ill connect you to the admin of the server im helping out with.
Reviving your stylo 6 is easier than you think and unlocking BL can be done with Chimera Tool. The more crucial project is getting the stylo 6 BL unlocked without using Chimera.
You can crash preloader also using https://www.hovatek.com/blog/how-to-forc...brom-mode/ then just flash the files prepared from your kdz (first doing format all + download which will fail at some point) then flashing using download only.
Untick any partition that gives you verified boot as these aren't needed to revive the phone.
If you REALLY need to go around that verified boot error then this vide should help
(16-07-2021, 09:06 AM)Mastercodeon314 Would you happen to have a scatter file built to flash firmware thats been extracted from a stylo 6 kdz? i built a scatter file from my device in WwR, but its start and end addresses are different from the sizes of the images i have in the firmware extraction.
(16-07-2021, 04:09 PM)hovatek(16-07-2021, 09:06 AM)Mastercodeon314 Would you happen to have a scatter file built to flash firmware thats been extracted from a stylo 6 kdz? i built a scatter file from my device in WwR, but its start and end addresses are different from the sizes of the images i have in the firmware extraction.
You can follow https://www.youtube.com/watch?v=VxNT1NnrTc0
(16-07-2021, 09:05 PM)Mastercodeon314 I have followed the steps to generate my scatter file, and was able to generate it. However, when i try to load the scatter in sp flash tool, i get start and end address errors as seen in the attached pic. I have determined that the first entry that has a problem with the addresses is the efuse partition, and everything below that has problems with their addresses. How would i fix this? Do i have to align each partition's start and end address to the size of the image im going to flash?
(07-10-2021, 04:04 PM)thainhattam My stylo 6 Q730AM device brick, it just vibrates, I can't get it to boot brom with keys, anyone have any other way, I can't bypass the auth authentication to unbrick